How to Wind an Automatic Watch: A Step-by-Step Guide
To wind an automatic watch, unscrew the crown if it is screw-down, leave it in the first position, and turn it clockwise about twenty to thirty times
To wind an automatic watch, unscrew the crown if it is screw-down, leave it in the first position, and turn it clockwise about twenty to thirty times. Then set the time, push the crown in and screw it down. Once running, wrist movement keeps it wound during normal daily wear.
Automatic watches wind themselves through a rotor that spins with wrist movement, but they still need a manual wind after sitting unworn. Many new owners are unsure how far to wind or whether they can damage the watch. The process is simple and safe on modern calibres. This piece explains how to wind an automatic watch, how much to wind and how three common calibres behave.
Step by step
First, unscrew the crown if the watch has a screw-down crown. Leave it in the first, pushed-in position, which engages winding.
Second, turn the crown clockwise, usually twenty to thirty turns, until the seconds hand runs. Third, pull out to set the time, then push in and screw down. Knowing how to wind an automatic watch takes the worry out of restarting it.
How much to wind
Twenty to thirty turns starts most automatic movements and gives several hours of reserve. Wearing the watch tops it up.
Modern automatic movements use a slipping mainspring, so they cannot be overwound by hand. Winding stops adding tension once full.
When winding is needed
Winding is needed when an automatic has stopped after sitting unworn, usually after about 40 hours on common calibres.
Owners who rotate watches may wind before each wear or use a watch winder.
Three common calibres compared
Seiko NH35 in the Ratio Freediver RTF041. The NH35 hand-winds through the crown and hacks for precise setting. The 40mm watch has sapphire, a screw-down crown and 200m. It is a typical example when learning how to wind an automatic watch.
Where it falls short: about 40 hours of reserve means winding after weekends off.
Miyota 8215 in the Ratio FreeDiver Professional 500M 32BJ202A. The 8215 hand-winds and winds one way through its rotor, but does not hack.
Where it falls short: setting to the second needs a simple technique.
Seiko 6R35 in the Seiko Prospex SPB143. The 6R35 hand-winds and holds about 70 hours, bridging a weekend.
Where it falls short: its accuracy tolerance is wide for its price.
|
Calibre |
Hand-winding |
Hacking |
Power reserve |
|
Seiko NH35 |
Yes |
Yes |
About 40h |
|
Miyota 8215 |
Yes |
No |
About 40h |
|
Seiko 6R35 |
Yes |
Yes |
About 70h |
The honest trade-offs
Hand-winding is quick and safe on modern calibres. Longer reserves reduce how often winding is needed. Calibres without hacking need a small setting technique.
Who benefits
New automatic owners and anyone rotating several watches benefit from learning how to wind an automatic watch correctly.
Frequently Asked Questions
How many times should an automatic watch be wound?
About twenty to thirty turns of the crown starts most automatic movements and gives several hours of reserve. Wearing the watch then keeps it wound. A full wind may take more turns, depending on the calibre. Stopping when resistance is felt is good practice.
Can an automatic watch be overwound?
Modern automatic movements use a slipping mainspring, so they cannot be overwound by hand. Once full, the mainspring slips rather than adding tension. Winding gently is still good practice. There is no need to count turns precisely, and stopping after twenty to thirty is fine.
Which way should the crown turn to wind?
Most automatic watches wind by turning the crown clockwise, away from the wearer, in the first position. Turning it the other way usually does nothing. The watch's manual confirms the direction for each calibre. Gentle, steady turns are best for the crown and stem.
Does a screw-down crown need unscrewing to wind?
Yes. The crown must be unscrewed before winding or setting. After winding and setting, push it back in and screw it down fully to keep the watch sealed against water. Checking that it is fully screwed down before swimming is essential.
Do all automatic watches hand-wind?
Most modern automatics do, including the Seiko NH35 and Miyota 8215. Some older or simpler calibres cannot be hand-wound and must be restarted by gently moving the watch. Checking the specifications confirms whether hand-winding is available on a given model.
Is a watch winder necessary?
No. A winder is convenient for owners who rotate several watches, but hand-winding before wearing works just as well. Watches worn daily stay wound through normal wrist movement. The choice depends on how many watches are in rotation. Both approaches work.


